Showing posts with label standard rate turn. Show all posts
Showing posts with label standard rate turn. Show all posts

Tuesday, October 28, 2008

ROT

From Wikipedia, the free encyclopedia

The aviation term ROT stands for rate one turn, also known as a standard rate turn. All aircraft must be able to perform a standard rate turn.

A standard rate turn for (light) airplanes is defined as a 3° per second turn, which completes a 360° turn in 2 minutes. This is known as a 2-minute turn, or rate one (= 180°/minute).
For heavy airplanes a standard rate turn is a 4-minute turn.

Instruments, either the turn and bank indicator or the turn coordinator, have the standard rate turn clearly marked. Light aircraft are equipped with 2-minute turn indicators while heavy aircraft are equipped with 4-minute turn indicators. This is very useful to pilots who are out of visual contact with the ground and for air traffic control when appropriate separation of aircraft is desired. The pilot banks the airplane such that the turn and slip indicator points to the standard rate turn mark and then uses a watch to time the turn. The pilot can pull out at any desired direction depending on the length of time in the turn.

A rate half turn (1.5° per second) is normally used when flying faster than 250 kt. The term rate two turn (6° per second) used on some high speed aircraft.


Angle of Bank formula

The formula for calculating the angle of bank for a specific True Airspeed (TAS) is:

\tan(bank)=\frac{TAS^2/r}{g}

where r is the radius of the turn and g is the acceleration due to gravity. For a rate one turn and velocity in kt (nautical miles per hour), this comes to

\tan(bank)=\frac{TAS(kt)}{364}.

A convenient approximation for the bank angle in degrees is

Angle\ of\ Bank \approx \frac{TAS(kt)}{10} + 7

Radius of Turn formula

One might also want to calculate the radius of a Rate 1,2 or 3 turn at a specific TAS.

Radius\ of\ turn\ in\ NM = \frac{TAS(kt)}{rate\ of\ turn\ (1\ or\ 2\ or\ 3) \times 60 \times \pi}

Use this formula to calculate the radius of turn in feet given velocity in knots and angle of bank:

Radius\ of\ turn\ in\ feet = \frac{velocity^2}{11.29 \times \tan(bank)}

This is a simplified formula that ignores slip and returns zero for 90 degrees of bank.

The constant 11.29 is calculated:

11.29 = \frac{9.8 \times 3600 \times 3600}{1852 \times 6076.12}

9.8 = gravity\ in\ metres\ per\ second\ per\ second

3600 = seconds\ per\ hour

1852 = metres\ per\ nautical\ mile

6076.12 = feet\ per\ nautical\ mile


Wednesday, September 10, 2008

Turn indicator

From Wikipedia, the free encyclopedia

Illustration of the face of a turn-and-slip indicator
Illustration of the face of a turn-and-slip indicator

A Turn Indicator is an aircraft flight instrument that shows the rate of turn. It is used by the pilot to maintain control when flying under Instrument flight rules.

Attitude and heading indicators function on the principle of rigidity, but rate instruments such as the turn-and-slip indicator operate on gyroscopic precession. Precession is the characteristic of a gyroscope that causes an applied force to produce a movement, not at the point of application, but at a point 90° from the point of application in the direction of rotation.

Turn-and-Slip Indicator

The rate gyro in a turn-and-slip indicator and turn coordinator.
The rate gyro in a turn-and-slip indicator and turn coordinator.

The first gyroscopic aircraft instrument was the turn indicator in the needle and ball, or turn-and-bank indicator, which has more recently been called a turn-and-slip indicator.

The inclinometer in the instrument is a black glass ball sealed inside a curved glass tube that is partially filled with a liquid, much like compass fluid. This ball measures the relative strength of the force of gravity and the force of inertia caused by a turn. When the aircraft is flying straight-and-level, there is no inertia acting on the ball, and it remains in the center of the tube between two wires. In a turn made with a bank angle that is too steep, the force of gravity is greater than the inertia and the ball rolls down to the inside of the turn. If the turn is made with too shallow a bank angle, the inertia is greater than gravity and the ball rolls upward to the outside of the turn.

The inclinometer does not indicate the amount of bank, neither is it limited to an indication of slip; it only indicates the relationship between the angle of bank and the rate of yaw. The turn indicator is a small gyroscope spun either by air or by an electric motor. The gyro is mounted in a single gimbal with its spin axis parallel to the lateral axis of the aircraft and the axis of the gimbal parallel with the longitudinal axis.

When the aircraft yaws, or rotates about its vertical axis, it produces a force in the horizontal plane that, due to precession, causes the gyro and its gimbal to rotate about the gimbal axis. It is restrained in this rotation plane by a calibration spring; it rolls over just enough to cause the pointer to deflect until it aligns with one of the doghouse shaped marks on the dial, when the aircraft is making a standard-rate turn.

The dial of these instruments is marked “2 MIN TURN.” Some turn-and-slip indicators used in faster aircraft like the Concorde are marked “4 MIN TURN.” In gliders, the calibration spring is usually set for a one minute standard rate turn. A standard-rate turn is being made whenever the needle aligns with a doghouse.

Precession causes a force applied to a spinning wheel to be felt 90° from the point of application in the direction of rotation.
Precession causes a force applied to a spinning wheel to be felt 90° from the point of application in the direction of rotation.

Turn Coordinator

Main article: Turn coordinator

The major limitation of the older turn-and-slip indicator is that it senses rotation only about the vertical axis of the aircraft. It tells nothing of the rotation around the longitudinal axis, which in normal flight occurs before the aircraft begins to turn.

A turn coordinator operates on precession, the same as the turn indicator, but its gimbal frame is angled upward about 30° from the longitudinal axis of the aircraft. This allows it to sense both roll and yaw. Some turn coordinator gyros are dual-powered and can be driven by either air or electricity. Rather than using a needle as an indicator, the gimbal moves a dial on which is the rear view of a symbolic aircraft. The bezel of the instrument is marked to show wings-level flight and bank angles for a standard-rate turn.

The inclinometer, similar to the one in a turn-and-slip indicator, is called a coordination ball, which shows the relationship between the bank angle and the rate of yaw. The turn is coordinated when the ball is in the center, between the marks. The aircraft is skidding when the ball rolls toward the outside of the turn and is slipping when it moves toward the inside of the turn.

A turn coordinator does not sense pitch. This is indicated on some instruments by placing the words "NO PITCH INFORMATION" on the dial.

The inclinometer of the turn coordinator indicates the coordination of aileron and rudder. The ball indicates whether the airplane is in coordinated flight or is in a slip or skid.
The inclinometer of the turn coordinator indicates the coordination of aileron and rudder. The ball indicates whether the airplane is in coordinated flight or is in a slip or skid.

Sources

This article incorporates text from Instrument Flying Handbook, a public domain work of the United States Government.